Commodore’s SX-64 has been an ahead-of-its-time, transportable colour pc based around the core technology in the legendary Commodore 64 (book). Sad to say, the SX-64’s external keypad is notoriously failure likely. In actuality, of those 2 keyboards I have, one is totally dead and one scarcely registers a key press (and in fact recently appears to get stuck key signals, so it is much worse). Regrettably, replacement keyboards are amazingly tricky to find and often involves buying another comprehensive system, which, if you’ve shopped for SX-64’s of late, you know is not affordable. Luckily, I’d find one solution to many an SX-64 owner’s dilemma, and that’s an offering from Jim Brain in Retro Innovations. Retro Innovations AdapterHow the SX-64 is intended to look. Although the options are somewhat confusing, if you move here, you can decide on the SX64 to/from PC option. My selected setup was as follows: (Configuration: SX64 to/from PC, Joyport Sockets: No, Assembled? Yes). After about a month, then I obtained my constructed board, which was ready-to-go. The design is straightforward enough. You take your SX-64 keyboard cable, plug that into the SX-64 as normal, then plug the other end to the slot within this gadget. Then you plug review azpen a746 7 inch quad core 8gb android tablet – armchair arcade in a PS/2 compatible keyboard using a Mini-DIN6 plug into the PS/2 port on your apparatus. At least that’s the concept. Unfortunately, it seems that the normal SX-64 cable doesn’t fit in the connector to the board (I tried both of mine), which I verified with Jim Brain via email (I need he’d made that known on the site or perhaps in our previous email addresses ). Though he recommended just using a regular DB25 cable (which it turns out is advocated on his other site), all of my DB25’s didn’t fit . My only option was to snip the plastic away on the SX-64 keyboard cable connector finish, which you may view in the photo. Ugly snipping, but nonetheless, it now matches. Since You can also see from the photo, my snipping handiwork with my Xuron 170-II Micro-Shear Flush Cutters was not good (I had to be particularly cautious to not snip any pins! ) , however it gave me an excuse to purchase some files to fix this up later (they need to also be good for helping to beautify a modification that I made into the removable lid onto a few of my Coleco Adams). How it all connects